IBM i: Postprocessing after installing an MDM server

July 20, 2009 at 6:43 pm

[] [] [] [] [] [] [] [] [] []

Symptom
As part of the installation of an MDM server on IBM i, some manual checks are required. This note describes these checks.
Other terms
i5OS, system i, AS/400, OS400, iSeries
Reason and Prerequisites
Check for correct installation
Solution
1. Required IBM PTFs
Before you can start operating an MDM server, the following PTFs must be active on your IBM i computer:
SI33372, SI33241, SI32914, SI34028, SI33157, SI34105, SI33949, SI34290, SI34000, SI34291, SI34212, MF46323, MF46651.
2. Check the reply list
Use the following two commands (under QSECDOFR authorization) to check if the reply list contains the correct entries:
ADDRPYLE SEQNBR(50) MSGID(CPA7025) RPY(’I’)
ADDRPYLE SEQNBR(3201) MSGID(CPA32B2) RPY(’I’)
If required, add the replies with another suitable SEQNBR.
If QSQSRVR jobs are still active in QSYSWRK, you must terminate them before using ADDRPYLE: ENDPJ SBS(QSYSWRK) PGM(QSYS/QSQSRVR).
These jobs can be started using the command [...]

Installation of SAP NetWeaver MDM 7.1 on IBM i

July 15, 2009 at 1:56 am

[] [] [] [] [] [] [] [] [] [] [] [] [] [] []

Symptom
Additional information needed when installing SAP NetWeaver MDM 7.1 system and other MDM related services on an IBM i host.
Other terms
as400, as400, iSeries, i5, IBM i, MDM 7.1, Installation, MDS, MDIS, MDSS, MDLS
Reason and Prerequisites
The actual installation procedure is described in the MDM 7.1 installation guide. Here you will find further information and hints that complement the information that is already in the installation guide.
You can get the official MDM 7.1 documentation including the installation guide http://service.sap.com/installmdm71
This note also contains information that came after the documentation was published.
Solution
This SAP Note is available in English only.
Topics [...]